NS0-180 Online Practice Questions and Answers

Regarding clustered Data ONTAP 8.3, what happens to the roles of the on board ports, HBAs, and NICs?

A. These roles are assignet when LIFs are created.

B. These roles are assigned based on the controller type.

C. These roles are predefined and must be changed before creating your LIFs.

D. The roles are divided into two categories: Data Management and Node Management.

Click the Exhibit button.

You are asked to install a 6-node cluster running clustered Data ONTAP 8.3 using Cisco switches. The customer has installed Config Advisor on a PC on their network and has asked you to help them collect data.

Referring to the exhibit, which three parameters should be selected? (Choose three.)

A. Enable management switch connections

B. Switchless

C. Enable cluster switch connections

D. Cisco NX5010/NX5020/5596/5596T

E. NetApp CN1610/CN1601

What is s LIF?

A. a logical internet file

B. a logical inventory file

C. a logical interaction file

D. a logical interface

You have completed the installation of a 4-node cluster. The customer did not purchase management switches and will not allow your laptop on the network.

In this situation, what are two valid procedures that will allow you to collect the Config Advisor output? (Choose two.)

A. Bring a switch that allows you to connect your laptop to all the switches and controllers.

B. Connect to a single controller in the cluster since it can run commands on every node.

C. Ask the customer to install and run Config Advisor on one of their PCs on the network.

D. Connect four USB serial cables to your laptop to allow you to connect to all four controllers.

You are asked to install a cluster that consists of two FAS8060 controllers and four DS2246 shelves. The customer wants two stacks of shelves (10-11 and 20-21).

According to NetApp, how many SAS cables are required to complete this installation with MPHA?

A. 10 SAS cables

B. 12 SAS cables

C. 8 SAS cables

D. 6 SAS cables

What is a protocol?

A. SnapRestore

B. CIFS

C. SnapMirror/SnapVault

D. FlexClone

According to NetApp best practices, which two sets of protocols would be assigned to the same storage virtual machine (SVM)? (Choose two.)

A. FCP, NFS

B. CIFS, iSCSI

C. NFS. CIFS

D. FCP, iSCSI

A customer wants you to add a disk shelf that contains SSDs so they can implement Flash Pool.

Which three tools would you use to complete this task? (Choose three.)

A. Use the My AutoSupport tool to ensure that Flash pool is licensed.

B. Use Hardware Universe to ensure that you would not exceed the maximum drive count.

C. Use Hardware Universe to ensure that you would not exceed the maximum cache for the system.

D. Use the My AutoSupport tool to see if there is a Flash Cache card installed.

E. Use Config Builder to verify the shelves can be added.

A customer is installing a new system and has determined that they have a broken disk.

What information is required to open a NetApp Support case?

A. disk HBA firmware and serial number

B. mainboard rev. id

C. serial number or system ID

D. disk shelf serial number and shelf ID number

You are creating a first data aggregate on the fourth node of a clustered Data ONTAP system that has only 600 GB SAS disks.

According to the NetApp naming convention, what is the appropriate name for the aggregate?

A. aggr10

B. n04.SAS_aggr10

C. n04_SAS_aggr01

D. n04-aggr01-SAS