HP2-Z30 Online Practice Questions and Answers

Which Layer 2 mechanism should be used to authenticate wireless or wired users before allowing them access to network resources?

A. 802.1X

B. MIMO

C. 802.1Z

D. WPA

Refer to the network exhibit.

Assume the network shown in the exhibit has implemented RSTP Based on the topology, which port is a root port?

A. SwrtchAport2

B. SwitchD port 1

C. SwitchC port 2

D. SwitchB port 1

Which protocol only requires MAC addressing?

A. LLDP

B. DHCP

C. NTP

D. Syslog

Which Intelligent Management Center (IMC) device discovery method is the default for device auto discovery?

A. ARP-based

B. PPP protocol-based

C. network segment-based

D. LDAP-based

What is the console port designation for an HP Comware switch?

A. interface console

B. con 0

C. aux 0

D. console

Which console cable is used on an HP Comware switch?

A. cross-over

B. rollover

C. USB

D. straight-through

Which FlexArchitecture component uses Virtual Connect in blade server systems?

A. FlexFabric

B. FlexDataCenter

C. FlexManagement

D. FlexCampus

The external server shown in the exhibit requires redundancy that uses link aggregation with LACP. Whichsolution meets this criteria?

A. Comware switches that use distributed trunking or ProVision switches that use meshed stacking

B. Comware switches that use IRF or ProVision switches that use distributed trunking

C. Comware or ProVision switches that use distributed trunking

D. Comware switches that use IRF or ProVision switches that use meshed stacking

Which trends of today's data center networks is the HP FlexNetwork Architecture designed to meet?

A. virtualization

B. Intelligent Resilient Framework

C. network analytics

D. server decentralization

A network administrator has an HP Comware switch that is configured with OSPF. The network administrator views the routing table and sees that a default route was learned from an OSPF neighbor (10.1.1.1). However, the network administrator wants to override this action and use a different neighbor (10.1.1 2) for the default route.

The network administrator configures this command:

[Comware] ip route-static 0.0.0.0 0 10.1.1.2

After configuring the command, the network administrator examines the routing table and notices that the original neighbor's default route is still in the routing table, but the static route is missing.

What is the cause of this problem?

A. OSPF routes have a lower precedence value

B. The ip default-gateway command must be used when creating a default route

C. Only one routing protocol can be operational on a Comware device

D. The static route has a syntax mistake