HP2-T23 Online Practice Questions and Answers

Which tool can you use to upgrade the firmware of an HP 3Gb SAS BL Switch?

A. Centralized Management Console

B. Virtual Connect Manager

C. Virtual SAS Manager

D. Systems Insight Manager

Which Virtual Connect module enables FCoE or iSCSI connectivity for BladeSystem server blades?

A. VC1/10Gb-F

B. VC-FC8/24

C. VC FIexFabric

D. VCFIex-10

HP standard warranties support HP hardware. What are HP Care Packs designed to support?

A. Software

B. Storage

C. Business

D. Network

You replaced a Smart Array P812 in a ProLiant DL380 G7 storage server. What should you do next?

A. Check the FBWC charge.

B. Replace the cache module.

C. Verify that the firmware level is current.

D. Install the BBWC battery.

An administrator must replace a defective processor located in slot 1 in an Intel-based ProLiant DL5860 Gen8 server:

What should the administrator do?

A. Install the second processor in slot 1.

B. Confirm that processor memory board 1 is installed before removing the processor.

C. Open the fan cage before removing the processor.

D. Open the heat sink retaining bracket to remove the processor.

A support engineer is installing DIMMs of different speeds and voltages in a ProLiant DL380p Gen8 Server. Which rules for DIMM installation must the engineer follow during this installation?

A. Four quad-ranked LRDIMMs are supported across all memory channels. The server balances capacity automatically.

B. RDIMMs operating at either 1.35V or 1.5V may be mixed in any order. The system will operate at the lower voltage.

C. DIMMs of different speeds may be mixed in any order. The server will select the lowest common speed.

D. UDIMMs, RDIMMs, and LRDIMMs may be mixed in the same bank in the server if only one processor is installed.

What are features of Option ROM Configuration for Arrays (ORCA)? (Select two.)

A. Smart Array Advanced Pack license registration

B. Online spare assignment

C. Drive expansion

D. Ability to set the stripe size

E. RAID level migration

An administrator installed HP CS Platinum/Platinum Plus Power Supplies in an enclosure with ProLiant server blades.

Which additional components does the administrator need in order to track power usage and automate server discovery in the enclosure?

A. HP iPDU and HP Power Regulator

B. HP Insight Control and RBSU

C. HP iPDU and HP Remote Support

D. HP iPDU and HP Insight Control

You ate installing a new HP BladeSystem c7000 enclosure. The customer wants to configure the iLO and interconnect IP addresses so that they are automatically maintained during a hardware swap How should you configure the enclosure?

A. Use the Insight Display fixed IP feature.

B. Configure the IP on each device and enable one enclosure IP mode.

C. Use Insight Control Server Deployment to configure the enclosure.

D. Use Enclosure-Bay IP Addressing.

How do you boot into Intelligent Provisioning on a ProLiant Gen8 server?

A. By pressing the F9 button during POST

B. By pressing the F10 button during POST

C. Through a Scripting Toolkit server configuration script

D. Through the Array Configuration Utility (ACU) in offline mode