DES-4421 Online Practice Questions and Answers

DRAG DROP

An administrator is using the OME-M GUI to change the hostname on an unconfigured I/O module inserted in slot A1. They log on to the MX7000 chassis home page.

What is the correct order of steps the administrator should take to set the management IP address?

Select and Place:

A new administrator has just taken over an MX7000 Multi-Chassis Management Group and two-racks of PowerEdge servers. The previous administrator no longer works at the company and is not available. No one knows the password for the OME-M interface and the default password is not working.

What must be used to reset the password?

A. iDRAC for one of the compute sleds.

B. Left ear control panel.

C. RACADM using a serial connection

D. Management Module jumpers

A server sled has a single mezzanine card installed in the correctly supported slot. To which IOM fabric(s) does the sled have access?

A. Fabric A1 and Fabric A2

B. Fabric A1 only

C. Either Fabric A or Fabric B, depending on the configuration set in OME-M

D. Fabric A1 and Fabric B1

What is a characteristic of MX7000 networking in Full Switch Mode?

A. Layer 2 bridging is disabled by default and interfaces must join a bridge domain (VLAN) before being able to forward frames.

B. Networking is enabled by default and all switch-specific OS10EE capabilities are available.

C. Networking is available on MX9116n FSE and MX7116n FEM but not on the MX5108n.

D. Switches operate as layer 2 I/O aggregation devices and are managed through OME-M.

Which controller option the mapping of an entire MX5016s to multiple compute sleds?

A. PERC H730 only

B. HBA330 only

C. H745 Jumbo PERC

D. HBA330 and PERC H730

At the initial release of the MX7000 for a daisy-chained configuration in a multi-chassis management group (MCM)m what is the maximum number of member chassis allowed, not counting the lead chassis?

A. 9

B. 10

C. 16

D. 20

Which MX7000 feature allows an administrator to virtualize network WWN and MAC addresses?

A. FlexAddress

B. MX Scalable Architecture

C. Identity Pool

D. Virtual Top of Rack

A technician has replaced an MX chassis tub. They complete the tub installation and power on the chassis. They notice that the KVM is no longer functional. What should the technician do after confirming the KVM feature is still enabled in OME-M?

A. Ensure all cables connecting the tub to the left ear control panel are connected properly

B. Ensure all power supplies are connected and powered-on

C. Ensure all cables connecting the tub to the right ear control panel are connected properly

D. Ensure all installed Management Modules are connected to the network

Refer to the exhibit.

How many internal server-facing ports are available on this I/O module for the MX7000 chassis?

A. 2

B. 8

C. 16

D. 24

What is the maximum possible weight of a fully populated MX7000 chassis?

A. 250 Ibs (114 kg)

B. 300 Ibs (136 kg)

C. 400 Ibs (182 kg)

D. 500 Ibs (227 kg)