250-251 Online Practice Questions and Answers

Which command retrieves and archives detailed information about the VCS configuration?

A. hasavecf

B. hasnap

C. hasave

D. haconfig

Under which condition will the service group attempt to fail over with default service group attribute settings except FaultPropagation=0?

A. System failure

B. Jeopardy

C. Critical resource fault

D. Set ManageFaults=ALL

Cluster systems are using a NIC teaming method. Both nic1 and nic2 have been used to create the virtual network interface named nic. The NIC resource is using the teamed nic device. If nic1 is the currently active interface, what is the effect on the NIC resource if nic1 fails?

A. You must use the MultiNIC resource for this configuration.

B. The operating system fails over the IP addresses from nic1 to nic2.

C. The NIC resource will fault causing the service group to fail over.

D. The NIC resource moves the IP addresses from nic1 to nic2.

Which agent entry point is used when running a virtual fire drill?

A. Info

B. Online

C. Offline

D. Action

What can be used to install VCS on remote systems using the provided install script? (Choose two.)

A. http

B. rcp

C. rsh

D. ftp

E. ssh

When preparing to install VCS on the systems named S1 and S2, which methods can be used to verify software compatibility? (Choose three.)

A. Check the VCS release notes for supported software.

B. Run the installvcs recheck S1 S2 command.

C. Run the installvcs heck S1 S2 command.

D. Run the installvcs ompat S1 S2 command.

E. Check the Symantec Enterprise Support Web site.

What is the maximum number of levels a group dependency tree can have?

A. Two

B. Three

C. Four

D. Five

An administrator wants to create an online local firm group dependency with GroupA as the child of GroupB. What is used to make this modification?

A. hagrp -link GroupB GroupA online local firm

B. hagrp -link GroupA GroupB online local firm

C. hagrp -dep GroupB GroupA online local firm

D. hagrp -dep GroupA GroupB online local firm

A service group is configured to run on SystemA and SystemB. A critical resource faults when the service group is online on SystemA, however the service group fails to automatically switch to SystemB. When viewing the status of the service group, it is in an OFFLINE|FAULTED state. Which default setting has been changed, preventing the service group from switching to SystemB?

A. ManageFaults

B. AutoFailOver

C. FaultPropagation

D. TFrozen

Consider the following configuration:

While GroupA is online, all of the systems in the cluster are rebooted simultaneously. All of the systems finish booting and successfully join the cluster. What will happen to the service group, GroupA?

A. It will start on SystemA.

B. It will remain offline on all systems.

C. It will resume its state before the reboot.

D. It will start on SystemA in a frozen state.