156-836 Online Practice Questions and Answers

In a dual MHO environment, MHO1 and MHO2 are connected to the SGM line cards in which way?

A. MHO1 and MHO2 are connected to the SGMs using the Sync cable.

B. MHO1 and MHO2 are connected to the line cards in any order administrators see fit.

C. MHO 1 is connected to the even-numbered ports, while MHO2 is connected to odd- numbered ports.

D. MHO 1 is connected to the odd-numbered ports, while MHO2 is connected to even- numbered ports.

There are two 10Gbps dual-port NICs and one 40Gbps NIC installed on a 23800 Appliance in slots 1, 2 and 3 accordingly. Which interfaces should be connected to Orchestrator 1 for downlinks' intra-orchestrator redundancy when using two Orchestrators?

A. Port 1 in Slot 2 and Port 2 in Slot 1

B. This configuration is not supported

C. Any pair of available ports

D. Port 1 in Slot 1 and Port 2 in Slot 1

What is the purpose of Management ports located on the Rear Panel of the Orchestrator MHO-140?

A. 1Gbps connectivity for Security Groups

B. Reserved for internal purposes. Not in use.

C. Out-of-band interfaces for access to Orchestrator itself

D. Additional ports used as uplinks

Which command do you use to find bottlenecks in the system that are affecting performance, even functionality in some cases?

A. asg stat -v

B. asg diag verify

C. asg perf -v

D. asg monitor

What is the Correction Layer?

A. Correction Layer is a daemon which corrects errors on Backplane interfaces

B. Correction Layer is a mechanism which handles asymmetric connections in multi- appliance system. For example, in case of NAT

C. Correction Layer is a mechanism which activated in case of asymmetric routing

D. Correction Layer is a Layer of GAIA OS which corrects misspelled commands and allows them to execute

What command can be run to show which SGM is selected to receive traffic?

A. g_tcpdump

B. asg monitor

C. dxl calc

D. asg calc

What is the max amount of Orchestrators in Dual-site setup?

A. 2 per Security Group

B. 4 per Security Group

C. 2

D. 4

There are two appliances within the same Security Group. One of them is connected by One downlink only, another one by Two downlinks. Assuming there's no NAT and no VPN, what would be proportion of traffic distribution done by Orchestrator?

A. 100%/0%

B. 33%/66%

C. 50%/50%

D. 66%/33%

In case of Correction, where is information about Owner stored?

A. In Correction table of Target Appliance

B. In Connection tables of all Appliances participating in Correction Layer flow

C. In Correction tables of all Appliances participating in Correction Layer flow

D. In Connection table of Target Appliances

What is the purpose of g_tcpdump command?

A. Collects traffic dump from all Active Appliances within Security Group

B. Collects traffic dump from CIN network

C. Collects traffic dump from Sync network

D. The same as tcpdump, just on Scalable Platform