156-835 Online Practice Questions and Answers

For a VSX configuration ?Which statement is wrong?

A. All Virtual Systems exist on the SMO

B. All Virtual Systems exist on all Appliances

C. VSX configuration is the same on all Appliances within the same Security Group

D. Each Appliance owns different Virtual Systems

What cannot be a reason for DETACHED status of Appliance when runningasg monitor command?

A. Appliance reboots

B. Appliance is a member of Security Group, but currently disconnected

C. Appliance installed with R80.20

D. There's an issue with Downlink cable

What cannot be learned from the output ofasg monitorcommand?

A. Appliances cluster status

B. Port status

C. Uptime

D. Security Policy status

What is the minimal amount of cables needed in order to connect an Appliance to an Orchestrator?

A. Three cables: uplink, downlink, SYNC

B. One Downlink cable only

C. Two cables: one uplink and one downlink

D. Four cables: uplink, downlink, SYNC and Management

What is the default IP range of Sync network (with no increment)?

A. The same as Management network

B. 198.51.100.0

C. 192.0.2.0

D. 192.168.1.0

What is the Sync network on Appliances used for?

A. May be used for any purpose, but synchronization always have priority

B. To synchronize configurations and connections in between connection tables of different Appliances

C. To transfer configuration files from Orchestrators to Appliances

D. To transfer data in case of full utilization of the downlink interfaces

What command should be used for collecting diagnostic information about the orchestrator?

A. cpinfo

B. orch_info

C. cpview

D. asg pert -v

What is the purpose of RJ-45 connectors located at the front panel of the Orchestrator MHO-170?

A. Two Out-of-band interfaces for access to Orchestrator itself

B. Out-of-band interface for access to Orchestrator itself and Serial Console connector

C. 1Gbps connectivity for Security Groups

D. Reserved for internal purposes. Not in use

What kinds of transceivers are supported on Orchestrator MHO-140?

A. SFP, QSFP, QSFP28

B. SFP, SFP+, QSFP, QSFP28

C. SFP, SFP+, SFP28

D. SFP+, SFP28, QSFP

What is the maximum amount of Appliances within the same Security Group?

A. 16

B. 31

C. 52

D. 8